Four Post
Boot & Glove Dryer
67326
set uP anD oPeratinG instructions
®
Distributed exclusively by Harbor Freight tools .
3491 Mission Oaks Blvd., Camarillo, CA 93011
read this material before using this product.
Failure to do so can result in serious injury.
save tHis manual.
©
®
Copyright 2009 by Harbor Freight Tools . All rights reserved. No portion of this manual or any artwork
contained herein may be reproduced in any shape or form without the express written consent of
Harbor Freight Tools. Diagrams within this manual may not be drawn proportionally. Due to continuing
improvements, actual product may differ slightly from the product described herein. Tools required for
assembly and service may not be included.
For technical questions or replacement parts, please call 1-800-444-3353.
6. Use appliance only for it’s intended
use, Household use only. Do not use
outdoors.
throw rugs, runners or similar
coverings. Arrange cord away from
traffic area and where it will not be
tripped over.
7. To reduce the risk of electric shock,
do not immerse the appliance in
water or other liquids.
16. Use only in dry environments. Do not
use in bathrooms, laundry area, near
sinks or other sources of water.
8. Never yank cord to disconnect from
outlet; instead, grasp plug and pull
to disconnect. Do not use cord as
a handle or pull cord around sharp
edges or corners. Keep cord away
from heated surface. Loop cord
loosely around appliance when
storing.
17. This product is not a toy. Keep it out
of reach of children.
18. WARNING: Handling cord on this
product will expose you to lead,
a chemical known to the State of
California to cause cancer, and birth
defects or other reproductive harm.
Wash hands after handling.
9. Always disconnect from electrical
outlet when not in use.
(California Health & Safety Code §
25249.5, et seq.)
10. Do not operate with a damaged cord,
or if the appliance has been dropped
or damaged. To reduce the risk of
electric shock, do not disassemble
or attempt to repair the appliance,
take it to a qualified service person
for examination and repair. Incorrect
re-assembly or repair could cause
a risk of fire, electric shock, or injury
to persons when the appliance
19. The warnings, precautions, and
instructions discussed in this
instruction manual cannot cover all
conditions and situations that may
occur. It must be understood by
operator that common sense and
caution are factors which cannot be
built into this product, but must be
supplied by operator.
is used. Use only manufacturer’s
recommended accessories.
save tHese
11. Do not put any object into openings.
instructions.
12. This appliance is not for space
heating purposes.
13. DO NOT IMMERSE IN WATER. NE
PAS IMMERGER.
14. Maintain labels and nameplates on
the tool. If unreadable or missing,
contact Harbor Freight Tools for a
replacement.
15. Do not run Power Cord under
carpeting. Do not cover cord with
SKU 67326
For technical questions, please call 1-800-444-3353.
Page 3
sPeciFications
120 V~ / 60 Hz / 230 W
Electrical Requirements with heat, 30 W without
heat
Rocker Switch:
No Heat / Heat
Timer Switch:
Off, variable to 3
hours, with 10 minute
increments, up to 180
minutes
Control
Knob
(13)
Settings
HouseHolD use only
Heat
Switch
(14)
e224797
Figure 2
unPackinG
When unpacking, make sure that the
item is intact and undamaged. If any parts
are missing or broken, please call Harbor
Freight Tools at 1-800-444-3353 as soon
as possible.
set uP & oPeration
read the entire rules For
saFe oPeration section at
the beginning of this manual
including all text under
subheadings therein before set
up or use of this product.
comPonents & controls
Long Tube (2)
to Prevent
serious injury
Wind Tube (17)
From acciDental
oPeration or electric
sHock:
Control Knob (13)
Before assembly, cleaning or
adjustment, make sure the
cord is unplugged, and the
unit has cooled.
Toe Support (3)
note: For additional information regarding
parts listed, refer to Assembly
Diagram at back of manual.
This dryer is for drying socks, gloves
and mittens as well as footwear and
boots.
Short Tube (1)
(Inside Long Tube)
Heat Switch (14)
Figure 1
SKU 67326
For technical questions, please call 1-800-444-3353.
Page 4
5. When the items are dry, remove
them, unplug the unit and store in a
dry location away from children.
set up
For smaller items, place the item
directly over the Wind Tube (17).
Pull the wrist area of gloves up over
the gloves to prevent them from
restricting airflow.
note: Drying time will vary depending on
temperature and humidity.
Smaller items will dry faster than
larger items.
For tall items, such as boots, set up
the two Long Tubes (2) as follows:
Footwear should be dried after every
use to prevent bacteria or fungus
growth.
a. Slide the Short Tube (1) inside the
large end of the Long Tube (2).
b. Fit the Toe Support (3) onto the
remaining end of the Long Tube,
sliding the Tube edge into the slot on
the Toe Support.
c. To Safely balance the unit, slide the
Tube assemblies over diagonally
opposite Wind Tubes (17). The Short
Tube holes are off center, so check
to make sure that the thinner side
of the tube is closest to the center
of the unit so you will have plenty of
room to slide the boot in place.
d. Slide the boot over the Tube
assemblies, making sure that the
entire unit is balanced so it will not
tip over during use.
operation
1. Place the dryer on a flat, level
surface. Set the control knob to the
off position.
2. Plug the unit into a 120V outlet.
3. Select Heat or No Heat with the Heat
Switch (14).
4. Set the Control Knob (13) to the
desired drying time. To set the time
to less than one hour, turn the Knob
past the one hour mark, then return it
to the desired time.
SKU 67326
For technical questions, please call 1-800-444-3353.
Page 5
insPection anD
maintenance
to Prevent
serious injury
From acciDental
oPeration or electric
sHock:
Before appliance inspection or
maintenance, make sure the
cord is unplugged, and the unit
has cooled completely.
to Prevent serious injury
From aPPliance Failure:
Do not use damaged
appliances. if abnormal noise
or vibration occurs, have the
problem corrected before
further use.
1. BeFore eacH use, inspect
condition of the dryer. Check for loose
screws, cracked or broken parts, and
any other condition that may affect its
safe operation.
2. Clean regularly to prevent dust from
accumulating on surfaces. Use a
damp cloth to clean, then dry before
use.
3.
WarninG! if the supply cord
of this tool is damaged, it must
be replaced only by a qualified
service technician.
SKU 67326
For technical questions, please call 1-800-444-3353.
Page 6
Parts list
Part
Description
Qty
2
2
2
1
1
1
1
1
Part
Description
Qty
1
4
1
1
1
1
1
2
1
2
3
4
5
6
7
8
9
Short Tube
16 Wire Mesh
Long Tube
17 Wind Tube
18 Top Stand
Toe Support
Power Cord
Right Enclosure
Power Cord Connector
Motor Bracket
Motor
19 Bottom Stand
20 Right Plate
21 Right Mica Plate
22 Heating Element
23 Side Mica Plate
24 Side Plate
Fan
1
2
10 Left Enclosure
11 Timer
12 Control Panel
13 Control Knob
14 Heat Switch
15 Heater Assembly
1
1
1
1
1
1
25 Middle Mica Plate
26 Thermostat
27 Fuse
28 Left Mica Plate
29 Left Plate
2
1
1
1
1
10
9
8
7
4
5
6
3
11
12
13
14
15
2
16
17
29
28
27
26
25
1
24
23
22
21
18
20
Heater Assembly (15)
19
SKU 67326
For technical questions, please call 1-800-444-3353.
Page 7
Please reaD tHe FolloWinG careFully
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLy DIAGRAM
IN THIS MANUAL AS A REFERENCE TOOL ONLy. NEITHER THE MANUFACTURER OR DISTRIBUTOR MAKES
ANy REPRESENTATION OR WARRANTy OF ANy KIND TO THE BUyER THAT HE OR SHE IS qUALIFIED
TO MAKE ANy REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS qUALIFIED TO REPLACE ANy PARTS
OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR ExPRESSLy STATES THAT
ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN By CERTIFIED AND LICENSED
TECHNICIANS, AND NOT By THE BUyER. THE BUyER ASSUMES ALL RISK AND LIABILITy ARISING OUT OF
HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT
OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.
Parts list anD assemBly DiaGram
record Product’s serial number Here:
note:If product has no serial number, record month and year of purchase instead.
note:Some parts are listed and shown for illustration purposes only, and are not available individually as
replacement parts.
SKU 67326
For technical questions, please call 1-800-444-3353.
Page 8
|